Toro Groundsmaster 3200 Series Operator's Manual page 24

Removing the Cab
1. Remove the cab roof
2. Remove the ROPS stops and ROPS mounts
(Figure 15).
Note:
Do not remove the firewall.
3. Remove the covers and roll bar seals from the
base of ROPS inside the cab
Note:
Return all the hardware that you removed
to the original mounting location in the order it
is used to secure the cab to the machine. This
can prevent losing the mounting hardware and
simplify installation.
4. Install the left and right panels inside the cab
(Figure 10).
5. Connect the cab hoist to the 4 lift points on the
cab (Figure 12).
6. Raise the cab to a height that will allow you to
safely move the machine away from the cab.
7. Move the machine away from the cab.
8. Lower the cab onto the shipping pallet to allow
you to move it to a storage location.
Note:
Secure the wire harness and hoses to
prevent damaging them when you lower or
store the cab. Cover the cab to prevent dust
and debris from accumulating on it while it is in
storage.
9. Move the ROPS pins and bolts back to their
original positions
10. Torque each bolt to 91 to 113 N∙m (67 to 83 ft-lb).
11. Install the bolt and nut securing the traction
pedal (Figure 1).
12. Install the front mower-deck latch from the front
of the machine (Figure
13. Rotate the armrest into position and Install the
bolts (Figure 5).
14. Install the vent tube on each side to the roll bar
(Figure 6).
(Figure 11).
(Figure 14).
(Figure 2 and Figure 3).
4).
24