5. Before transferring, check the communication link between
the two units by pressing the TEST COMM key. The status
bar should display the message REMOTE LINK OK.
6. To move waypoints and routes into this master unit from the
other unit, press the START key. The status bar displays the
message TRANSFERRING and updates every second with the
number of waypoints and routes already received against the
total quantity to be received. The progress bar, located below
the
status
bar,
completed.
If there's a problem with the transfer process, the following
messages may appear:
•
If the other unit is off-line, the master unit displays the
dialog-box message COULDN'T GET REMOTE WAYPT/
ROUTE COUNT and the status-bar message
COMMUNICATION ERROR.
•
If the other unit doesn't contain any waypoints and routes,
the master unit displays the dialog-box message NO
WAYPTS OR ROUTES TO TRANSFER and the status-bar
message NO TRANSFER DONE.
•
If the master unit is completely full of waypoints and routes
(no more room available), the master unit displays the
032101
graphically
displays
– 13 –
the
percentage
Addendum P/N GM210