Table of Contents
Advertisement
displays the message READY TO TRANSFER to show that the
transfer is ready to start.
5. Before transferring, check the communication link between
the two units by pressing the TEST COMM key. If the status
bar now displays the message REMOTE LINK OK, you may
begin to transfer waypoints.
6. To move waypoints and routes from the master unit into the
other unit, press the START key. The status bar displays the
message TRANSFERRING and updates every second with the
number of waypoints and routes sent compared to the total
quantity to be sent. The progress bar, located below the
status bar, graphically shows the percentage completed.
If there's a problem with the transfer process, the following
messages may appear:
•
If the other unit is off-line, the master unit displays the
dialog-box message TRANSFER ABORTED BY
COMMUNICATION TIMEOUT and the status-bar message
COMMUNICATION ERROR.
•
If the master unit doesn't contain any waypoints and routes,
the master unit displays the dialog-box message NO WAY-
PTS OR ROUTES TO TRANSFER and the status-bar message
NO TRANSFER DONE.
Addendum P/N GM210
– 16 –
032101
Advertisement
Table of Contents
