Table of Contents
Advertisement
If you press any function key on the master unit during the
transfer, the error message
HIT
will be displayed, the process will be aborted, and the
master unit will display the particular screen accessed by that
function keypress. You can press any key on the other unit,
however, without interrupting the transfer process.
To purposely stop the transfer at any time, press the
key. If you press the
dialog-box message
and the status bar displays the message
ABORTED
. Waypoints and routes transferred up to that point
are in the receiving unit (be aware that a particular route may
not contain all of its waypoints due to the transfer interruption).
START
Press the
process (this means that all waypoints and routes, not just the
ones already in the receiving unit and the ones left to be
transferred, are re-transferred).
1. Select the unit you'd like to use as the master. Remember:
You can use either of the two units as the master because
both units are capable of importing or exporting waypoints
and routes.
2. At the master unit, press the WAYPTS/ROUTES key to
display the WAYPTS AND ROUTES screen.
032101
NOTE:
TRANSFER ABORTED BY KEY
STOP
key, the master unit displays the
TRANSFER ABORTED BY KEY HIT
key again to re-start the entire transfer
– 11 –
STOP
,
TRANSFER
Addendum P/N GM210
Advertisement
Table of Contents
