Philips CARDIOMD Service Manual page 93

Procedure
For an overview of CardioMD covers, see
Chapter 2 System Overview.
4. Loosen the 4 screws shown holding the X
drive motor.
5. Lift the motor to disengage the drive gear.
6. Manually move the pillar as far towards
the front of the system as it will go until
the mechanical end stop is reached.
7. Move the pillar towards the rear of the
gantry approximately 3 – 4 mm.
8. Use an Allen key to loosen the ultimate
end stop code wheel.
1MAN0158-H11 04-2005 CSIP Level 1
Details
I, II III
Calibration
CardioMD Service Manual 4-37