Philips CARDIOMD Service Manual page 251

Procedure
If working in a solid wall, use the plugs
supplied for this purpose (the larger plug and
screw shown in the photo on the right):
4. Use an 8 mm drill to drill holes for the
wall plugs supplied with the kit.
5. Insert a plug into the hole just drilled. Seat
plug firmly into the wall by tapping with a
hammer.
6. Fasten the mounting plate with the first
screw.
7. Level the wall mount plate and mark the
remaining 3 upper holes, as well as the 4
lower mounting holes.
Note. It is critical that the wall mounting plate is level.
Procedure
8. Remove the wall mounting plate to give
access to drilling the 7 remaining holes.
9. Mount anchors/plugs. Seat anchors/plugs
firmly into the wall by tapping with a
hammer.
10. Mount the plate and tighten all 8 mounting
screws.
1MAN0158-H11 04-2005 CSIP Level 1
Details
Details
Installation
CardioMD Service Manual 8-49