During Operation; During Operation Safety - Toro Reelmaster 7000-D Operator's Manual

Seat Armrest Adjusting Knob
Rotate the knob to adjust the seat armrest angle
(Figure 43).
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle
43).
Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft
43).
Weight Adjusting Lever
Adjust the seat to your weight
the lever to increase the air pressure and push down
to decrease the air pressure. The proper adjustment is
attained when the weight gauge is in the green region.
Weight gauge
The weight gauge indicates when the seat is adjusted
to the weight of the operator
adjustment is made by positioning the suspension
within the range of the green region.

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Before you start the engine, ensure that all drives
are in neutral, the parking brake is engaged, and
you are in the operating position.
•
Do not carry passengers on the machine and keep
bystanders and children out of the operating area.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
(Figure
(Figure
(Figure 43). Pull up on
(Figure 43). Height
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Keep your hands and feet away from the cutting
units.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Stop the cutting units whenever you are not
mowing.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
•
Do not leave a running machine unattended.
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage and lower the cutting units.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
– Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
Rollover Protection System
(ROPS) Safety
•
Do not remove any of the ROPS components from
the machine.
•
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
•
Always wear your seat belt.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace all damaged ROPS components. Do not
repair or alter them.
Machines with a Foldable Roll Bar
•
Always use the seat belt with the roll bar in the
raised position.
28