Adjusting The Cutting Unit-Turnaround Height; Folding The Roll Bar - Toro Reelmaster 7000-D Operator's Manual

Adjusting the Cutting
Unit-Turnaround Height
The lift-arm switch (Figure
right, front lift arm (cutting unit #5).
Figure 52
1. Lift-arm switch
2. Switch bracket (slotted)
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Loosen the 2 flange-head screws that secure
the switch bracket to the carrier frame for the
front cutting unit-lift arms.
3. Move the switch bracket as follows:
•
To increase the cutting unit-turnaround
height, move the bracket up.
•
To decrease the cutting unit-turnaround
height, move the bracket down.
4. Tighten the 2 flange-head screws.

Folding the Roll Bar

•
Keep all nuts, bolts, and screws correctly torqued
ensure that the equipment is in safe working
condition.
•
Replace worn or damaged parts for safety.
•
Ensure that the seat belt and mountings are in
safe working order.
•
Wear the seat belt when the roll bar is raised and
no seat belt when the roll bar is lowered.
You can fold the roll bar down to allow access into
areas with restricted height.
40) is located behind the
3. Flange-head screw
WARNING
The machine does not have a rollover
protection system (ROPS) when the roll bar is
folded down and should not be considered
a ROPS.
Do not wear a seatbelt when the roll bar is
lowered.
WARNING
When lowering and raising the roll bar, your
fingers may get pinched between the machine
and the roll bar.
Use caution when lowering and raising the
roll bar to prevent your fingers from getting
pinched between the machine and the roll bar.
WARNING
g370721
The roll bar is an integral safety device. It
does not protect you from injury or even
death from a rollover unless it is secured in
the raised position and you are wearing the
seat belt.
• Keep the roll bar in the raise position
whenever you operate the machine.
• Lower the roll bar temporarily only when
necessary, then secure it in the raised
position as soon as possible before
continuing operation.
Important:
The roll bar is an integral safety
device. Keep the roll bar in the raised position
when operating the mower. Lower the roll bar
temporarily only when absolutely necessary.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Remove the lynch pins that secure the roll-bar
pins at each side of the roll bar
33
(Figure 53).