Operation
Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
Transport Position
When transporting a load, keep the attachment as
close to the ground as possible, no more than 15 cm
(6 inches) above the ground. Tilt it rearward to keep
the load level.
1. No more than 15 cm (6
inches) above the ground
Figure 6
2. Tilt the load rearward
Operating Tips
•
To adjust the forks, slide them along the frame to
the desired width. Adjust the forks to the widest
possible setting to ensure that the load is as stable
as possible.
•
When transporting a load, keep the forks as close
to the ground as possible.
•
Never use the forks for prying as damage may
occur.
•
Never attempt to lift more than the load rating
capacity.
g242374
7