Toro Reelmaster 7000-D Operator's Manual page 13

Installing the Hose Guide
Cutting Units 5
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure 11).
Figure 12
1. Hairpin
2. Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (Figure 13).
Figure 11
5. Cutting unit 5
6. Reel motor
7. Weight
g375672
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3. Align the studs of the right hose guide with
the holes in the cutting-unit frame and the
turf-compensator bracket
Note:
Ensure that the support loop of the
hose guide aligns toward the centerline of the
machine.
1. Stud (hose guide )
2. Turf-compensator bracket
g375689
4. Assemble the hose guide and turf-compensator
bracket to the cutting-unit frame with the 2 flange
locknuts (3/8 inch).
5. Torque the locknuts to 37 to 45 N∙m (27 to 33
ft-lb).
13
Figure 13
3. Flange locknut (3/8 inch)
(Figure 14).
Figure 14
3. Flange locknut (3/8 inch)
4. Inboard
g375690
g375688