Toro Reelmaster 7000-D Operator's Manual page 20

Mow-Speed Limiter
When the mow-speed limiter
forward, it allows the cutting units to engage and limits
the maximum ground speed during mowing. You
change the position of the spacers to adjust mowing
ground speed. When driving machine between job
sites, rotate the mow-speed limiter back for maximum
transport speed.
Lower Mow/Raise Control Lever
Use the lower mow/raise control lever
raises and lowers the cutting units. The lever also
starts and stops the reels when the reels are enabled
in the mow mode.
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the transport position.
Figure 36
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 36).
PTO Switch
The PTO switch (Figure
and D . Press the PTO button forward to
ISENGAGE
engage the cutting-unit blades. Press the button back
to disengage the cutting-unit blades.
(Figure 35) is rotated
(Figure
4. PTO switch
5. Engine-throttle control
6. Headlight switch
36) has 3 positions: O
.
36) has 2 positions: E
Engine-Throttle Control
Use the engine-throttle control
or decrease the engine speed.
Headlight Switch
Press the switch to turn on the headlights
Power Point
Use the power point
36)
12-volt electrical accessories.
1. Power point
Bag Holder
g025902
Use the bag holder
Backlap Levers
Use the backlap levers to control the cutting unit
rotation direction when backlapping the reels
38).
,
FF
NGAGE
1. Front cutting-unit backlap
lever
20
(Figure 36) to increase
(Figure
(Figure 37) to power optional
Figure 37
2. Bag holder
(Figure 37) for storage.
Figure 38
2. Rear cutting-unit backlap
lever
36).
g368823
(Figure
g370565