Mow Speed-Spacer Table; Adjusting Maximum Mow-Ground Speed - Toro Reelmaster 7000-D Operator's Manual

1. Check/fill plug
2. O-ring
3. Check the O-ring for the plug is not worn or
damaged.

Mow Speed-Spacer Table

Adjusting Maximum
Mow-Ground Speed
Adjusting the Mow Speed-Spacers
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Use the Mow Speed-Spacer Table to determine
the maximum ground speed when you mow,
and the position of the short spacers that limit
Figure 99
3. Reduction-gear case
41).
4. Check the gear-case oil level.
Note:
The gear-oil level is correct if the oil level
is at the bottom of the check/fill-plug hole.
5. If the gear-oil level is low, add enough of the
specified case oil to bring the level up to the
bottom of the check/fill-plug hole.
6. Install the check/fill plug.
g370243
Figure 100
mow-ground speed; refer to
Table (page
Note:
Each short spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph).
3. Below the traction pedal, remove the stop bolt
and flange locknut that secure the spacers to
the mow-stop block
58
Mow Speed-Spacer
58).
(Figure 101).
g368821