Setup; Adjusting The Front Cutting Unit Roller Position; Installing The Cutting Units - Toro Reelmaster 7000-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Adjusting the Front Cutting
Unit Roller Position
No Parts Required
Procedure
Note:
1. Determine if you need to adjust the roller
position. The width of the cutting unit that you
install determines the roller position at the roller
support as follows:
•
27-inch cutting units—upper mounting holes
of the roller support.
•
32-inch cutting units—lower mounting holes
of the roller support.
Description
No parts required
Front hose guide (right)
Front hose guide (left)
No parts required
Qty.
–
1
1
–
Qty.
1 Read the manual before operating the machine.
1 Read the manual before operating the engine.
1. Roller support
2. Upper holes—27-inch
cutting units
2. If needed, remove the capscrew, locknut, and
roller.
3. Align the roller to the other roller support holes.
4. Secure the roller to the roller support with the
capscrew and locknut.
5. Repeat steps
the machine.
10
Use
Adjust the front cutting unit roller
position.
Install the cutting units.
Prepare the machine.
Use
Figure 3
3. Lower holes—32-inch
cutting units
2 through 4 at the other side of
g019541