Checking The Hydraulic-Fluid Level; Replacing The Hydraulic Filters - Toro Reelmaster 7000-D Operator's Manual

4-wheel drive traction unit
Hide thumbs Also See for Reelmaster 7000-D:
Table of Contents

Advertisement

US gallons) pails or 208 L (55 US gallons) from
your authorized Toro distributor.
Checking the
Hydraulic-Fluid Level
Service Interval: Before each use or daily
The reservoir is filled at the factory with high-quality
hydraulic fluid.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Clean the area around the filler neck and cap of
the hydraulic tank
Figure 115
1. Hydraulic-tank cap
2. Dipstick
3.
Remove the hydraulic-tank cap from the tank.
4.
Remove the dipstick from the filler neck and
wipe it with a clean rag.
5.
Insert the dipstick into the filler neck; then
remove it and check the fluid level.
The correct hydraulic-fluid level is between the
Full mark and the Add mark on the dipstick.
6.
If the level is low, add the specified hydraulic
fluid to raise the fluid level to the Full mark.
7.
Install the dipstick and hydraulic-tank cap to the
tank.
41).
(Figure
115).
3. Full mark
4. Add mark
Replacing the Hydraulic
Filters
Service Interval: Every 1,000 hours—If you
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
replace the hydraulic filters.
Use the following Toro hydraulic filters:
Name
Return filter
Charge filter
Important:
Using another type of filter may void the
warranty on some components.
Replacing the Charge Filter
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Tilt the seat; refer to
3.
Clean the area around the charge filter and filter
head
(Figure
g370529
1. Charge-filter head
4.
Align a drain pan under the filter, and remove
the filter.
5.
Wipe the filter mounting filter surface of the filter
head with a clean rag.
6.
Lubricate the new filter gasket and fill the
filter with the specified hydraulic fluid; refer to
Hydraulic Fluid Specifications (page
67
are using the recommended
hydraulic fluid, replace the
hydraulic filters.
Toro Part No.
Location
94-2621
Below the right
frame channel.
75-1310
Under the seat
plate.
41).
Tilting the Seat (page
116).
Figure 116
2. Charge filter
42).
g370535
66).

Advertisement

Table of Contents
loading

This manual is also suitable for:

03781

Table of Contents