Toro Reelmaster 7000-D Operator's Manual page 12

Figure 7
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3. Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit (Figure
Note:
Do not remove the flange serrated nut
from the capscrew.
Figure 8
1. Capscrew
2. Right tab (Carrier frame)
4. Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
9) with the flange locknut (3/8 inch).
3. Flange locknut (3/8 inch)
8).
3. Flange locknut (3/8 inch)
(Figure
g375690
1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the studs of the left hose guide with
the holes in the cutting-unit frame and the
turf-compensator bracket
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
g375691
1. Turf-compensator bracket
2. Flange locknut (3/8 inch)
6. Assemble the hose guide and turf-compensator
bracket to the cutting-unit frame with the 2 flange
locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
12
Figure 9
3. Capscrew
(Figure 10).
Figure 10
3. Stud (hose guide)
4. Inboard
g375694
g375687