Preparing The Machine - Toro Reelmaster 7000-D Operator's Manual

Installing the Reel Motors
1. Coat the spline shaft of the reel motor with clean
grease.
2. Oil the reel motor O-ring and install it onto the
motor flange.
3. Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
Figure 32
1. Reel-drive motor
4. Rotate the motor counterclockwise until the
flanges encircle the bolts, and then tighten the
bolts.
Important:
Make sure that the reel motor
hoses are not twisted, kinked, or at risk of
being pinched.
5. Torque the mounting bolts to (27 to 33 ft-lb).
Entering Cutting Unit Settings
Enter the following cutting-unit information into the
InfoCenter:
•
Blade count; refer to
(page 24).
•
Mow speed; refer to
24).
•
Height of cut; refer to
(HOC) (page 24).
Note:
You need the PIN code to change the blade
count, mow speed, and height of cut values in the
InfoCenter.
(Figure 32).
2. Mounting bolts
Setting the Blade Count
Setting the Mow Speed (page
Setting the Height of Cut
3

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the
cutting units, and engage the parking brake.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Check the tire air pressure before use; refer to
Checking the Tire Air Pressure (page
Note:
The tires are overinflated for shipping.
Adjust the tire air pressure before operating the
machine.
4. Check the rear-axle lubricant level; refer to
Checking the Oil Level of the Rear Axle (page
56).
5. Check the hydraulic-fluid level; refer to
g004127
the Hydraulic-Fluid Level (page
6. Grease the machine; refer to
Bearings and Bushings (page
Important:
machine will result in premature failure of
critical parts.
7. Open the hood and check the coolant level; refer
to Checking the Coolant Level (page
8. Check the level of the engine-oil level, and
close and latch the hood; refer to
Engine-Oil Level (page
Note:
The engine ships with oil in the
crankcase; however, check the oil level before
and after the engine is first started.
18
67).
Greasing the
44).
Failure to properly grease the
Checking the
47).
54).
Checking
62).