Toro Reelmaster 7000-D Operator's Manual page 17

Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1. Remove the lynch pin and washer securing the
lift-arm pivot shaft to the lift arm and slide the
lift-arm pivot shaft out of the lift arm
Figure 28
1. Lift arm (rear cutting unit)
2. Lift-arm pivot shaft
2. Insert the lift-arm yoke onto the carrier frame
shaft (Figure 29).
Figure 29
1. Lift-arm pivot shaft
2. Thrust washer
(countersunk)
3. Slide a cutting unit under the lift arm
(Figure 28).
g368648
3. Thrust washer
4. Lynch pin
g368650
3. Carrier-frame shaft
4. Lynch pin
(Figure 30).
1. Lift arm (rear cutting unit)
2. Lift-arm pivot shaft
4. Insert the lift-arm shaft into the lift arm and
secure it with the lynch pin.
5. Repeat steps
cutting unit.
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (Figure
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
17
Figure 30
3. Thrust washer
4. Lynch pin
1 through 4 for the other rear
31).
Figure 31
3. Snapper pin
g368687
g003948