Positioning the Turf Compensating
Spring
Cutting Unit 2
Figure 15
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1.
If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure
16).
Figure 16
1. Hairpin
2.
Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame
(Figure
17).
g379514
5. Cutting unit 5
6. Reel motor
7. Weight
g375689
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3.
Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit
(Figure
Note:
Do not remove the flange serrated nut
from the capscrew.
1. Capscrew
2. Right tab (Carrier frame)
4.
Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
19) with the flange locknut (3/8 inch).
14
Figure 17
3. Flange locknut (3/8 inch)
18).
Figure 18
3. Flange locknut (3/8 inch)
g375690
g375691
(Figure