Changing The Oil In The Rear Axle; Checking The Lubricant In The Reduction-Gear Case - Toro Reelmaster 7000-D Operator's Manual

1. Check plug (axle housing)
3. Check the gear oil level in the axle through the
check-plug hole.
Note:
The gear-oil level is correct if the oil level
is at the bottom of the check-plug hole.
4. If the gear-oil level low, remove the fill plug and
add the specified gear oil to raise the oil level to
the bottom of the check-plug hole.
5. Install the check plug.
6. If removed, install the fill plug.
Changing the Oil in the
Rear Axle
Service Interval: After the first 200 hours
Every 800 hours
Rear Axle Oil Capacity: 2.4 L (80 fl oz)
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Clean the area around the 3 drain plugs
97)—1 at each bevel-gear case (outboard of the
axle housings) and 1 in the center-gear case.
1. Drain plug (axle case—outboard)
2. Axle housing
3. Drain plug (center gear case)
Figure 96
2. Fill plug (axle housing)
41).
Figure 97
3. Remove each drain plug
the oil to drain into a drain pan.
4. Remove the 2 axle housing check plugs and the
fill plug to ease in draining of the oil
g009716
1. Check plug (axle housing)
5. Install the 3 drain plugs and the check plug at
the axle housing with the breather fitting.
6. At the fill plug axle port, fill the axle with
approximately 2.37 L (80 fl oz) of 85W-140 gear
oil or until the oil level is at the bottom of the hole.
7. Install the check plug and the fill plug.
Checking the Lubricant in
the Reduction-Gear Case
Service Interval: Before each use or daily
Every 400 hours (Also check the lubricant
before you first start the engine.)
Reduction-Gear Case Oil Specification: SAE
(Figure
85W-140 gear oil
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Remove the check/fill plug from the left side of
the reduction-gear case
g369856
57
(Figure 97) and allow
(Figure
Figure 98
2. Fill plug (axle housing)
41).
(Figure 99).
98).
g009716