Table of Contents
Advertisement
not have a grounding wrist strap, make sure you are properly
grounded before you touch any electronic component.
Four-Port and Dual-Port 10/100 Ethernet NICs
The IP1200 Series supports Nokia-approved, four-port and dual-port UTP5
dual-mode (10-Mbps and 100-Mbps) Ethernet NICs installed in a 6U PMC
carrier. When you purchase a 10/100 Ethernet NIC with your IP1200 Series,
the NIC is installed before the appliance is delivered to you. For information
about how to add or replace a NIC, see
Network Interface Cards."
10/100 Ethernet NIC Features
The four-port 10/100 Ethernet NIC supports PCI operation at 100 MHz and
runs on Nokia IPSO v3.8 or higher.
The dual-port 10/100 Ethernet NIC supports PCI operation at 66 MHz.
Both the four-port and dual-port Ethernet NICs support the following
features:
You can configure and monitor Ethernet NIC interfaces by using Nokia
Network Voyager. Specifically, you set the port speed and full-duplex or
half-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related
reference materials, see
Information"
Nokia IP1200 Series Security Platform Installation Guide
Hot swappability
Tracing through tcpdump
PCI operation at 33 MHz and 66 MHz
Compliance with IEEE 802.3z Gigabit Ethernet specification
on page 48.
Four-Port and Dual-Port 10/100 Ethernet NICs
Chapter 4, "Installing and Replacing
"Accessing Nokia Network Voyager Reference
75
Advertisement
Table of Contents
