Replacing Or Upgrading Memory - Nokia IP1200 Series Installation Manual

8
Installing and Replacing Other Components
4. Gently pull the hard disk drive forward to remove it from the appliance.
5. Insert the new hard disk drive until it locks into place.
6. Tighten the retaining screws on both sides of the hard disk drive.
7. Press the hot swap button to restore power to the hard disk drive.
8. Use Nokia Network Voyager, Lynx, or the CLI to implement disk

Replacing or Upgrading Memory

The Nokia IP1200 Series Security Platform has four dual inline memory-
module (DIMM) sockets. This section describes how to upgrade or replace
the memory by using a Nokia-approved memory upgrade kit.
The IP1260 security platform comes with 1 GB of memory in two 512 MB
DIMMs and can be upgraded to a maximum of 2 GB of RAM.
The IP1220 security platform comes with 512 MB of memory in two 256 MB
DIMMs and can be upgraded to a maximum of 2 GB of RAM.
128
The ejector and locking lever clicks into the locked position.
The IP1200 Series recognizes the new hard disk drive.
mirroring.
Nokia IP1200 Series Security Platform Installation Guide
00316
00316.1