Nokia IP1200 Series Installation Manual page 114

7
Troubleshooting
Note
Blank passwords are not accepted in Nokia Network Voyager or Lynx.
Finally, return the entire database to its default settings to initiate the initial
configuration process. The initial configuration process is described in
Chapter 2, "Performing the Initial Configuration."
To reset the default database settings
1. Log in to the IP1200 Series as admin by using Nokia Network Voyager.
2. Under Configuration Database Management (Config > System
3. Create the new default configuration.
Do Not Get a Login Prompt—Error Messages Appear
Problem The IP1200 Series is defective, or the file system on the IP1200
Series is defective.
Solution Contact the Nokia customer support site listed in
Information"
Note
Use the full installation procedure to install a new system. The new
system completely replaces the contents of the drive and might be
needed to restore or reload an IP1200 Series. This procedure erases any
configuration database on the appliance. For information about how to
114
After you execute this command, the system reports that the password
was not successfully changed. However, the password is changed and is
now newpassword.
For information about how to access Network Voyager and the related
reference materials, see
Configuration > Manage Configuration Sets), choose the option to create
a new factory default configuration.
on page 3.
"To open Nokia Network Voyager"
Nokia IP1200 Series Security Platform Installation Guide
on page 47.
"Nokia Contact