Table of Contents
Advertisement
5
About IP1200 Series Appliance Network Interface Cards
Caution
To protect the IP1200 Series and the memory modules from electrostatic discharge
damage, make sure you are properly grounded before you touch these components.
Use a grounding wrist strap and follow the instructions provided with the wrist strap
before you handle the components or open the appliance. The grounding plug on the
front of the appliance (shown in
point. If you do not have a grounding wrist strap, make sure you are properly grounded
before you touch any electronic component.
Four-Port 10/100 Ethernet NICs
The IP1200 Series supports Nokia-approved, four-port UTP5 dual-mode (10-Mbps and 100-
Mbps) Ethernet NICs installed in a 6U PMC carrier. When you purchase a 10/100 Ethernet NIC
with your IP1200 Series, the NIC is installed before the appliance is delivered to you. For
information about how to add or replace a NIC, see
Network Interface Cards and Accelerated Data Path (ADP) Services Modules."
10/100 Ethernet NIC Features
The four-port 10/100 Ethernet NIC supports PCI operation at 100 MHz and runs on Nokia IPSO
v3.8 or higher.
Both the four-port and two-port Ethernet NICs support the following features:
Hot swappability
Tracing through tcpdump
PCI operation at 33 MHz and 66 MHz
Compliance with IEEE 802.3z Gigabit Ethernet specification
You can configure and monitor Ethernet NIC interfaces by using Nokia Network Voyager.
Specifically, you set the port speed and full-duplex or half-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
"Using Nokia Network Voyager"
58
All manuals and user guides at all-guides.com
Figure 1
on page 20) provides a chassis grounding
on page 44.
IP1220 and IP1260 Security Platforms Installation Guide
Chapter 4, "Installing and Replacing
Advertisement
Table of Contents
