Nokia IP1200 Series Installation Manual page 138

8
Installing and Replacing Other Components
6. Push down on the card until it is properly seated on the motherboard.
7. Place the screws through the standoff holes on the card and into the
8. Turn each screw clockwise to attach the card to the standoffs.
9. To secure the connections, tighten the screws firmly, but do not
10. Slide the chassis assembly back into the appliance and resecure the four
11. Configure your software to use hardware acceleration by following the
138
The two sets of connectors should be aligned with each other. The four
screw holes and four standoffs should also be aligned with each other.
standoffs on the motherboard.
Make sure that all four standoff connections are properly aligned before
tightening the screws completely.
overtighten.
retaining screws.
Reseating the chassis assembly automatically restores power to the
appliance.
instructions in "Configuring Software to Use Hardware Acceleration"
page 139.
Screw
Accelerator card
Standoff hole
Motherboard standoff
Nokia IP1200 Series Security Platform Installation Guide
on