Note
Because the IP1200 Series supports hot swapping of NICs, you do not
have to turn off power from the system to remove, install, or replace a
NIC.
Before You Begin
Before you install the card, make sure that the rubber gasket around the front
of the card is installed properly.
To remove, install, or replace a NIC you need the following:
To replace a network interface card
1. Identify the location (PMC carrier and slot) of the NIC to be replaced.
2. Loosen the screws on each side of the PMC carrier. The screws are
3. Press the red buttons on the ejection and locking levers on the PMC
Nokia IP1200 Series Security Platform Installation Guide
Phillips-head screwdriver
Suitable, grounded work surface on which to place the PMC carrier
Replacement or new NIC
located behind the ejection levers.
Caution
To avoid damage to the ejection lever, loosen the retaining screw
behind each ejection lever before you remove the PMC carrier.
carrier.
The lock is released.
Removing, Installing, and Replacing NICs
63