Toro LT2240 Installation Instructions Manual page 7

Figure 12
1. Button-head screw (8 x 20
mm)
3. Pull through the control-arm harness connectors
with the following labels:
•
LIGHTS
•
INDICATORS
•
HAZARDS
4. Connect the 3 switches to the corresponding
harness connectors
Figure 13
1. Turn signal switch
2. Switch plate
(Figure 13 and Figure 14).
g344367
1. Headlight switch
5. Install the previously removed instrument panel
and switch plate from the control arm
11 and Figure
Installing the Switches
Models 31657 and 31659
1. Remove the 2 Phillips-head screws (1/4 x 1
inch) that secure the control-arm cover to the
control arm, and remove the cover
g344363
1. Phillips-head screw (1/4 x
1 inch)
2. Remove the Phillips-head screw (#10 x 3-1/2
inches), locknut (#10), and 5 flange-head screws
(#10 x 3/8 inch) that secure the right control-arm
panel to the control arm
7
Figure 14
2. Hazard switch
12).
(Figure
Figure 15
2. Control-arm cover
(Figure 14).
g344362
(Figure
15).
g344284