Toro LT2240 Installation Instructions Manual page 19

Assembling the Plate-Light
Connector
1. At the bulkhead, insert the terminal of the white
light wire into the pin 1 position of the 2-pin
connector (Figure
Figure 52
1. Pin 1 position (2-pin
connector)
2. White wire (number
plate-light harness)
3. Black wire (number
plate-light harness)
2. Insert the terminal of the black light wire into the
pin 2 position of the 2-pin connector
3. Insert the wedge lock into the 2-pin connector.
52).
4. Pin 2 position (2-pin
connector)
5. Wedge lock
(Figure
Securing the Plate-Light Harness
to the Bulkhead
1. Assemble a cushioned support clamp onto the
harness of the number-plate light
1. Flange locknut (6 mm)
2. Cushioned support clamp
2. Assemble the cushioned support clamp and
a flange nut (6 mm) onto the machine left
flange-head bolt
3. Tighten the 2 flange-head bolts and 2 flange
locknuts that secure the number-plate bracket
and clamp to the bulkhead.
g351247
11
Installing the Wire Harness
Parts needed for this procedure:
52).
1 Light kit wire harness
6 Adhesive clamp
2 Tube insert
1 Cushioned support clamp
8
Cable tie
Placing the Wire Harness Overview
Refer to Figure 54
harness routes on the machine.
19
(Figure
Figure 53
3. Flange-head bolt (6 x 20
mm)
4. Harness (number-plate
light)
(Figure 53).
for an overview of where the wire
53).
g349935