Toro LT2240 Installation Instructions Manual page 20

Figure 54
Preparing the Headlight Wire
Harness Connectors
1. Locate the 6-pin connector labeled LH
H and 6-pin connector labeled RH
EADLIGHT
H of the kit harness connectors
EADLIGHT
55).
Figure 55
1. 6-pin connector
(headlight—kit harness
connector)
2. Swivel-interface shell
2. Separate the 90° backshell from the
swivel-interface shell
3. Separate the swivel-interface shell from the
6-pin connector (Figure
4. Repeat steps 2 and
connector.
(Figure
3. 90° backshell
(Figure 55).
55).
3 of the other headlight
Routing and Connecting the Wire
Harness to the Front Light Bar
Assembly
1. Route the wire harness segment labeled LH
H
EADLIGHT
arm pivot-plate mount and then through the
latch plate
g344563
2. Route the wire harness segment labeled RH
H
EADLIGHT
arm pivot-plate mount and then through the
latch plate
3. Secure the harness to the front arm pivot-plate
mount using 2 adhesive clamps
4. Route the wire harness through the inside of the
left and right side of the front light bar assembly
(Figure 57).
5. Secure the wire harness at the front using 4
adhesive clamps
g347279
6. Route the wire harness through the hole in the
front channel by pushing the harness through
until you can see the harness from the side of
the light bar assembly
20
through the left opening in the front
(Figure 56).
Figure 56
through the right opening in the front
(Figure 56).
(Figure
(Figure 57).
Figure 57
(Figure 58).
g345099
56).
g344582