3.
Select the Config tab at the top of the screen
4.
Select Max Brake Pressure (psi) inside the Config menu and set the default as standard
5.
Adjust the brake-light pressure as follows:
Important:
When increasing or decreasing the pressure (psi), do so in 1 to 5 increments.
•
If the brake lights do not illuminate or do not illuminate quickly when you release the forward pedal,
reduce the pressure (psi).
•
If the brake lights remain illuminated or remain illuminated too long when you release the forward
pedal, increase the pressure (psi).
6.
Test the brake light; refer to
Finishing Calibration
1.
Shut off the engine, remove the key, and wait for all moving parts to stop.
2.
Disconnect the diagnostic cable from the C
3.
Assemble the cap onto the connector labeled C
Figure 88
(Figure
Testing the Brake Lights (page
D
AN
IAGNOSTIC
AN
32
88).
29).
P
connector.
ORT
D
P
.
IAGNOSTIC
ORT
g345518
(Figure
88).