Toro LT2240 Installation Instructions Manual page 16

Figure 43
1. Adapter fitting (1/4 x 7/16
inch)
2. Seal (1/4 inch)
4. Torque the adapter fitting to 34 to 41 N∙m (25
to 30 ft-lb).
5. Assemble the brake-pressure transducer into
the adapter fitting
6. Torque the transducer to 27 N∙m (20 ft-lb).
7. Plug the 3-pin connector labeled
PRESSURE SENSOR
transducer (Figure
Figure 44
1. Brake-pressure
transducer
3. Port-PS (front traction
manifold)
4. Brake-pressure
transducer
(Figure 43).
BRAKE
into the brake-pressure
44).
2. 3-pin connector (labeled
BRAKE PRESSURE
—machine wire
SENSOR
harness)
9
Assembling the Number
Plate
Machines without the Optional
Cab
Parts needed for this procedure:
1 Number plate
1 Number-plate bracket
1 Number-plate light
g344935
2 Phillips-head screw (#6 x 1 inch)
2 Locknut (#6)
2 Flange-head bolt (6 x 20 mm)
2 Flange nut (6 mm)
Procedure
1. Secure the number-plate light to the
number-plate bracket using the 2 Phillips-head
screws (#6 x 1 inch) and 2 locknuts (#6) as
shown in
Retain the connector and wedge lock for later
installation.
g344934
16
Figure 45.