Opening The Hood; Disconnecting The Battery - Toro LT2240 Installation Instructions Manual

Removing the Storage
Compartment
Models 31657 and 31659
1. At the left side of the operator's platform, open
the door of the storage compartment
1. Washer
2. Knob
2. Remove the 3 knobs and 3 washers that secure
the storage compartment to the machine, and
remove the compartment

Opening the Hood

Models 31654
Unlatch and open the hood.

Disconnecting the Battery

1. Loosen the forward nut of the negative
battery-cable terminal
(Figure
Figure 3
3. Storage compartment
(Figure 3).
(Figure 4).
3).
1. Nut (negative
battery-cable terminal)
2. Lift the negative battery cable from the battery
post (Figure
Note:
Position the negative-battery cable where
it cannot contact the negative battery post.
2
g328513
Installing the ROPS
Components
Parts needed for this procedure:
1 Right, rear light assembly
1 Left, rear light assembly
2 Bolt (16 x 110 mm)
2 Flange nut (16 mm)
Procedure
1. Remove the pivot bolt (16 x 100 mm) and flange
nut (16 mm) from the right side of the roll bar
(Figure 5).
Discard the pivot bolt (16 x 100 mm) and flange
nut (16 mm).
4
Figure 4
2. Negative battery post
4).
g344733