Toro LT2240 Installation Instructions Manual page 26

13
Installing the Fuses and
Flasher Relay
Models 31657 and 31659
Parts needed for this procedure:
2 Mini fuse (7.5 A)
1 Flasher relay
Procedure
1. Remove the fuse-block cover located next to the
battery (Figure 77).
Figure 77
1. Fuse block
2. Install the 2 mini fuses (7.5 A) into the fuse block
lighting and hazard locations
Note:
Use the decal on the fuse-block cover for
the fuse position.
3. Install the fuse-block cover
4. Inside the control arm, locate the 2-socket
connector of the control arm-harness labeled
R -F (Figure
ELAY LASHER
g328464
2. Fuse-block cover
(Figure 77).
(Figure 77).
78).
1. 2-socket
connector (labeled
R -F —control
ELAY LASHER
arm-harness)
5. Plug flasher relay into the 2-socket connector,
and secure relay and harness using a cable tie.
6. Install the control-arm cover
1. Phillips-head screw
26
Figure 78
2. Flasher relay
(Figure 79).
Figure 79
2. Control-arm cover
g347112
g344284