Toro LT2240 Installation Instructions Manual page 21

Connecting the Headlights
1. Assemble the swivel-interface shell to the 6-pin
connector (Figure
1. 6-pin connector
(headlight—kit harness
connector)
2. Swivel-interface shell
2. Assemble the 90° backshell to the
swivel-interface shell
Note:
Ensure that the conduit is secure to the
90° backshell.
3. Repeat steps 1 and
connector.
4. Connect the wire-harness connectors to the
right and left light assemblies
Figure 58
59).
Figure 59
3. 90° backshell
(Figure 59).
2 of the other headlight
(Figure 60).
5. Install the 2 tube insert into the sides of the front
g344617
light bar assembly
6. Secure the wire harness using cable ties.
g347278
Connecting the Light Wire Harness
to the Machine Wire Harness
1. At the lower ROPS-cross tube
remove the cap from the 6-pin connector of
the machine wire harness labeled L
H
ARNESS
21
Figure 60
(Figure 61).
Figure 61
(Figure
I (Figure
NTERCONNECT
Figure 62
g344574
g344583
62),
IGHTING
63).
g346879