Toro LT2240 Installation Instructions Manual page 22

Figure 63
1. Cap
2. 6-pin connector (labeled
L H
IGHTING ARNESS
I —machine
NTERCONNECT
wire harness)
2. Plug the 6-pin connector of the light kit
wire harness labeled L
I into the 6-pin connector of
NTERCONNECT
the machine wire harness labeled L
H I
ARNESS NTERCONNECT
Routing the Wire Harness
At the back of the electrical panel, route the kit wire
harness along machine wire harness at the bottom
of the panel (Figure 64).
g346878
3. 6-pin connector (labeled
L H
IGHTING ARNESS
I —light
NTERCONNECT
kit wire harness)
H
IGHTING ARNESS
IGHTING
(Figure 63).
Connecting the License Plate
Harness
Model 31654
1. At the back of the electrical panel, remove the
upper right locknut and washer that secure the
controller to the panel
1. Controller
2. Bolt (6 x 65 mm)
22
Figure 64
(Figure 65).
Figure 65
3. Washer
4. Locknut (6 mm)
g344639
g349956