Toro LT2240 Installation Instructions Manual page 13

Figure 32
1. Adapter fitting (1/4 x 7/16
inch)
5. Torque the brake-pressure transducer to 27 N∙m
(20 ft-lb).
6. Remove the cable tie that secures the 3-pin
connector of the machine wire harness labeled
BRAKE PRESSURE SENSOR
the forward traction manifold
Figure 33
1. 3-pin connector (labeled
—machine wire harness)
SENSOR
7. Route the 3-pin connector and wires toward the
right side of the traction pump.
2. Brake-pressure
transducer
to the hose adjacent to
(Figure 33).
BRAKE PRESSURE
8. Remove the cap from the brake pressure sensor
g344291
connector
g344439
1. Cap
2. 3-pin connector (labeled
BRAKE PRESSURE
—machine wire
SENSOR
harness)
9. Plug the brake pressure sensor connector into
the brake-pressure transducer
13
Figure 34
(Figure 35).
Figure 35
3. Brake pressure sensor
(Figure
g344293
g344325
35).