Toro LT2240 Installation Instructions Manual page 11

Assembling the Mounting
Brackets to the Light Bar
1. Align the holes in the mounting bracket with the
holes in the arm of the light bar
you identified in Identifying the Mounting Bracket
Hole Positions (page
Note:
Ensure that the tab of the mounting
bracket is aligned away from the light assembly.
Figure 26
1. Flange locknut (8 mm)
2. Tab (mounting bracket)
3. Washer (8 mm)
2. Loosely assemble the mounting bracket to the
light bar arm (Figure
mm), 2 washers (8 mm), and 2 flange locknuts
(8 mm).
3. Repeat steps 1 and
light bar.
7
Installing the Light Bar
Parts needed for this procedure:
2 Flange-head bolt (6 x 25 mm)
2 Flange locknut (6 mm)
4 Flange-head bolt (8 x 30 mm)
4
Flange locknut (8 mm)
Procedure
1. Align the holes in the light bar mounting brackets
with the holes in the latch plate and pivot-arm
plate (Figure 27,
(Figure
10).
4. Bolt (8 x 65 mm)
5. Light bar arm
26) with the 2 bolts (8 x 65
2 at the other arm of the
Figure 28, or Figure 29).
26) that
Model 31659 shown; Models 31654 and 31657 are similar.
1. Flange-head bolt (6 x 25
mm)
2. Latch plate
3. Mounting bracket
g345100 4. Flange locknut (6 mm)
11
Figure 27
5. Flange-head bolt (8 x 30
mm)
6. Pivot-arm plate
7. Flange locknut (8 mm)
Figure 28
Model 31654
Figure 29
Model 31657
g344558
g344556
g344557