Toro LT2240 Installation Instructions Manual page 17

Figure 45
1. Locknut (#6)
2. Number-plate bracket
2. Secure the number plate to the number-plate
bracket using 2 flange-head bolts (6 x 20 mm)
and 2 flange nuts (6 mm) as shown in
Figure 46
1. Flange nut (6 mm)
2. Number-plate bracket
g344531
3. Number-plate light
4. Phillips-head screw (#6 x
1 inch)
Figure
g344532
3. Flange-head bolt (6 x 20
mm)
4. Number plate
10
Installing the Number-Plate
Bracket and Light
Machines without the Optional
Cab
Parts needed for this procedure:
2 Flange-head bolt (6 x 20 mm)
3 Washer (1/4 x 3/4 inch)
2 Flange nut (6 mm)
1 Cushioned support clamp
Removing the Bulkhead
Remove 4 bolts, 4 lock washers, and 4 washers
that secure the bulkhead
panel, and remove the bulkhead.
Note:
Retain the bulkhead, bolts, lock washers, and
46.
washers.
1. Bolts
2. Lock washer
17
(Figure 47) to the electrical
Figure 47
3. Washer
4. Bulkhead
g346880