3.
Plug the diagnostic cable into the C
Contact your authorized Toro distributor for a cable.
4.
Plug the cable into the computer.
Calibrating the Brake-Pressure Transducer
Model 31654
1.
Open the D
ANFOSS
Contact your authorized Toro distributor for access to this program.
2.
Select Brake Light Parameters from the menu
3.
Adjust the brake-light pressure
•
If the brake lights do not illuminate or do not illuminate quickly when you release the forward pedal,
reduce the pressure (kPa).
•
If the brake lights remain illuminated or remain illuminated too long when you release the forward
pedal, increase the pressure (kPa).
4.
Test the brake light; refer to
D
AN
IAGNOSTIC
P
1 program.
LUS
(Figure
86) as follows:
Testing the Brake Lights (page
P
connector.
ORT
(Figure
86).
Figure 86
29).
30
g345519