Installation; Loose Parts - Toro LT2240 Installation Instructions Manual

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Description
No parts required
Right, rear light assembly
Left, rear light assembly
Bolt (16 x 110 mm)
Flange nut (16 mm)
Reflector
Headlight switch
Turn signal switch
Hazard switch
Front light bar assembly
Right light assembly
Left light assembly
Hex-head bolt (12 x 80 mm)
Light bar mount
Flange nut (8 mm)
Flange-head bolt (8 x 65 mm)
Washer (8 mm)
Flange-head bolt (6 x 25 mm)
Flange locknut (6 mm)
Flange-head bolt (8 x 30 mm)
Flange locknut (8 mm)
Pressure transducer
Fitting (3/4 x 7/16 inch)
Adapter fitting (1/4 x 7/16 inch)
Seal (1/4 inch)—For Machines with the
Differential Lock Kit installed only
Number plate
Number-plate bracket
Number-plate light
Phillips-head screw (#6 x 1 inch)
Locknut (#6)
Flange-head bolt (6 x 20 mm)
Flange nut (6 mm)
Flange-head bolt (6 x 20 mm)
Washer (1/4 x 3/4 inch)
Flange nut (6 mm)
Cushioned support clamp
Light kit wire harness
Adhesive clamp
Tube insert
Cushioned support clamp
Cable tie
Qty.
–
Prepare to install the road light kit.
1
1
Install the ROPS components.
2
2
2 Install the reflectors.
1
1 Install the light and hazard switches.
1
1
1
Assemble the front light bar assembly.
1
2
2
4
Install the light bar mounting brackets.
4
4
2
2
Install the front light bar.
4
4
1
1
Install the brake-pressure transducer.
1
1
1
1
1
2
Assemble the number plate.
2
2
2
2
3
Install the number plate and light.
2
1
1
6
2 Route the wire harness.
1
8
2
Use