Toro LT2240 Installation Instructions Manual page 14

Installing the Transducer
Models 31657 and 31659 without the
Differential Lock Kit
1. At the right side of the traction pump, remove
the plug from port MB of the pump
Figure 36
1. Port-MB (traction pump)
2. Plug
2. Assemble the reducer fitting into port MB of the
pump (Figure 36).
3. Torque the reducer fitting to 81 N∙m (60 ft-lb).
4. Assemble the brake-pressure transducer
37) into the reducer fitting (3/4 x 7/16 inch).
(Figure 36).
g343559
g344078
3. Reducer fitting (3/4 x 7/16
inch)
(Figure
1. Reducer fitting (3/4 x 7/16
inch)
5. Torque the transducer to 27 N∙m (20 ft-lb).
6. Remove the cable tie that secures the 3-pin
connector of the machine wire harness labeled
BRAKE PRESSURE SENSOR
the forward traction manifold
1. 3-pin connector (labeled
—machine wire harness)
SENSOR
7. Route the 3-pin connector and wires toward the
right side of the traction pump
8. Remove the cap from the 3-pin connector of the
machine wire harness labeled
(Figure
SENSOR
14
Figure 37
2. Brake-pressure
transducer
to the hose adjacent to
(Figure 38).
Figure 38
BRAKE PRESSURE
(Figure 39).
Figure 39
BRAKE PRESSURE
40).
g344080
g344440
g343559