Mitsubishi Electric GOT1000 Series Connection Manual page 380

12.3.3 PLC side setting
POINT POINT POINT
TOSHIBA PLC
For details of TOSHIBA PLCs, refer to the following
manual.
TOSHIBA PLC user's Manual

Setting of operation mode switch and station
No. switch
(1) Station No. setting switch
The station No. setting switches are hexadecimal rotary
switches that determine the station No. on the Ethernet
network.
Set the station address (1 to 254) that has been
assigned upon system configuration in a HEX code.
Assign an address with a different value to each of the
nodes in the system.
Switch name Setting details
STN-H Upper address : 0 to F (Hex.)
STN-L Lower address : 0 to F (Hex.)
12 - 12
12. CONNECTION TO TOSHIBA PLC
12.3 Ethernet Connection
Station No.
setting switch
Operation mode
setting switch
Setting range
01 to FE (Hex.)
(2) Operation mode setting switch
Description Settings
Normal OFF
Operation
mode
For maintenance
OFF
Class B
*1
172.16.64.XX
Reserved
IP address
type Class C
*2
192.168.0.XX
*3
Tool setting
*1 XX indicates the value of the station No. setting switches.
Subnet mask : 255.255.192.0
*2 XX indicates the value of the station No. setting switches.
Subnet mask : 255.255.255.0
*3 It can be set freely from the engineering tool, and the value
has precedence over the value of the station No. setting
switches.
12.3.4 Precautions

Delay of device communication
Note that if a non-existent station, or a station which
power is turned OFF is monitored, the communication
of normal stations is also delayed.

Redundant system
When configuring a redundant system, the "Multicast
address setting" for the configured PLC pair (System A:
Primary, System B: Secondary) is required.
Switch No.
1 2 3 6 7
OFF OFF
ON OFF OFF
ON OFF
OFF OFF
OFF ON
OFF OFF
ON ON
8
OFF
OFF
ON
ON