NEC Electra Elite IPK II Features And Specifications Manual page 977

Electra Elite IPK II
25-04-01 VRS/DISA Transfer Ring Group With No Answer/Busy
Set the destination that Automated Attendant (OPA) calls ring if the OPA caller dials an
extension that does not answer or is busy. This also sets the options for DISA calls. The system
allows Ring Groups or Disconnect = 0.
Ring Groups:
1~100
25-05-01 VRS/DISA Error Message Assignment
For each trunk that will be answered by the VRS, enter the VRS message (1~48) the outside
caller hears if they dial incorrectly after answer. If you enter 0, the call reroutes according to
Program 25-03 and Program 25-04. Make one entry for each Night Service mode.
25-06-01 VRS/DISA One-Digit Code Attendant Setup - Next Attendant Message Number
Set up single digit dialing for Automated Attendant callers. For each VRS Message programmed
to answer outside calls (see Program 25-02-01), specify the digit the Automated Attendant caller
dials (1~9, 0,
will not be able to dial system extensions.)
25-06-02 VRS/DISA One-Digit Code Attendant Setup - Destination Number
Set up single digit dialing for Automated Attendant callers. For each VRS Message programmed
to answer outside calls (see Program 25-02-01), specify the destination reached (four digits
maximum) when the caller dials the single digit code.
25-07-02 System Timers for VRS/DISA - VRS/DISA No Answer Time
If an Automated Attendant caller dials an extension that does not answer, the call will wait this
interval before rerouting to the Ring Group specified in Program 25-03 and 25-04. This setting
also affects unanswered DISA calls.
25-07-03 System Timers for VRS/DISA - Disconnect after VRS/DISA Re-Transfer to IRG
Set the timer for disconnecting a call after it is re-transferred to a ring group by VRS/DISA.
25-08-01 DISA User ID Setup Password
Set up password (6 digits).
25-13-01 System Option for DISA - VRS Password
Enter the password DISA callers must dial before the system will allow them to record, listen to
or erase VRS messages.
40-07-01 Voice Prompt Language Assignment for VRS
Select the language to be used for the VRS (default = 1, English). Although the system allows
this option to be changed in programming, the language will only change if the DSPDB has the
firmware which provides the newly selected language.
40-10-01 Voice Announcement Service Option - Fixed Message
Enable (1) or disable (0) the system's ability to play the fixed VRS messages (such as "You have
a message.").
Voice Response System (VRS)
∗
, #). (Keep in mind that if you assign destinations to digits 3 and 4, outside callers
Document Revision 1
2 - 955