NEC Electra Elite IPK II Features And Specifications Manual page 195

Electra Elite IPK II
Toll Restriction
Trunk Group Routing
Trunk Groups
Programming
10-03-03 Setup, For SLIU Unit - Transmit CODEC Gain Type
10-03-04 Setup, For SLIU Unit - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for 500/2500 type single
line telephones.
11-01-01 System Numbering
Setup number to be used for Service codes to access trunks.
11-09-01 Trunk Access Code
If required, change the single-digit Trunk Access Code (normally 9). If you change this code, you
must also review the settings in 11-01-01 for the new code selected.
11-09-02 Trunk Access Code - Alternate Trunk Route Access Code
Assign the Service Code set up in 11-01-01 for Alternate Trunk Route Access.
11-10-27 Service Code Setup (for System Administrator) - Trunk Port Disable
Define the service code which should be used by an extension user to block a trunk from being
used for outgoing calls (Default: 645).
11-11-13 Service Code Setup (for Setup/Entry Operation) - Display Language Selection for
Multiline Terminal
Select the service code which can be used at an extension to change the displayed language on
a multiline terminal's display (default: 678).
11-12-01 Service Code Setup (for Service Access)
Define the service code which should be used by an extension user to select outgoing Trunk
Group (code 704).
14-01-01 Basic Trunk Data Setup - Trunk Name
To make identifying calls easier, assign a name to each trunk.
14-01-02 Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 Basic Trunk Data Setup - Receive CODEC Gain Type
Assign a CODEC Gain Type to each trunk. This sets the amount of gain (amplification) for the
selected trunk.
14-01-07 Basic Trunk Data Setup - Outgoing Calls
For each trunk, allow (1) or prevent (0) outgoing calls.
Central Office Calls, Placing
Document Revision 1
2 - 173