Measuring Cables; Laying Out Cables - Huawei FusionModule1000A20 Installation Manual

FusionModule1000A20 IT Solution
Installation Guide (2016.05, AI Version)

10.2 Measuring Cables

Prerequisites
Containers and external cable trays have been installed.
Preparations
Tools: thin rope, protective gloves, measuring tape
Material: cable
Document: none
Skill requirement: common technicians
Procedure
Step 1 Select a cable to be connected. Measure the cable length required using a thin rope based on
the cable route.
Step 2 Determine the cable length based on the measurement result of
----End

10.3 Laying Out Cables

Prerequisites


Preparations
Tools: protective gloves, marker
Material: cable
Document: none
Skill requirement: common technicians
Issue 02 (2017-01-10)

To improve installation efficiency, complete all cable measurements before you perform subsequent
operations.
 Determine the length of the other cables between the containers based on the length of the cable
measured.
 To facilitate installation, it is recommended that you lay out cables to the measured cable route
length plus about 2 m.
The outdoor area without shelters is free from bad weather condition such as raining,
sandstorm, strong wind, or snowing.
Cables have been measured.
Some external cables for the FusionModule1000 are long and have a large diameter. Assign sufficient
people to lay out cables especially armored cables if no assistant tool is available onsite.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Cable Installation Techniques
Step 1 and the tolerance.
69