Replacing A Water Sensor - Huawei FusionModule2000 V500R002C03 Maintenance Manual

FusionModule2000 Smart Modular Data Cente
Maintenance Guide
Step 2 Cut off the cable ties that bind the temperature sensor and its cable, and remove the
temperature sensor and its cable.
Step 3 Bind a new temperature sensor to the original position in the cabinet.
Step 4 Bind the cable of the new temperature sensor to the cabinet along the original cable route, and
connect the cable to the rack environment unit.
Step 5 Verify that the temperature sensor function is normal.
----End

6.4.10 Replacing a Water Sensor

The water sensor can be installed in various scenarios. This section describes the general
method for replacing a water sensor.
Context
Prepare a water sensor or water detection cable of the same model.
A water sensor consists of a water detection cable, water detector, and conversion cable. The
water detection cable is laid out on the floor, connected to the water detector placed near the
collector by the conversion cable.
Figure 6-42 Water sensor components
(1) Water detector
(4) Conversion cable end B,
connecting to water the
detection rope
Issue 03 (2019-12-04)
(2) Conversion cable end A,
connecting to the water detector
(5) Water detection rope end A,
connecting to the conversion
cable
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
(3) Conversion cable
(6) Water detection
rope
74