Replacing A Multi-Functional Sensor - Huawei FusionModule2000 V500R002C03 Maintenance Manual

Smart modular data center

Table of Contents

FusionModule2000 Smart Modular Data Cente

Maintenance Guide

6.4.7 Replacing a Multi-Functional Sensor

Impact on the System

The temperature, humidity, and smoke cannot be sensed.

Preparations



Procedure

Step 1 The multi-functional sensor is clamped into a base through a slot and a buckle. Hold down the

multi-functional sensor and slide it to the side to remove the sensor.

Figure 6-40 Removing a multi-functional sensor

Step 2 Disconnect cables from the rear of the multi-functional sensor.

Step 3 Connect the cables to the reserved multi-functional sensor.

Step 4 Align the slot in the rear of the reserved multi-functional sensor with the buckle on the base,

and slide and clamp the multi-functional sensor.

Step 5 Synchronize the parameters of the multi-functional sensor on the ECC800 WebUI.

Step 6 On the WebUI of the ECC800, choose Monitoring > System > ECC800 > Controls >

Delete device with communication failure, and click Submit.

Step 7 Log in to the ECC800 WebUI, and edit the plan view by adding new devices.

Step 8 Check the parameters and communication status of the multi-functional sensor to ensure

normal communication.

----End

Issue 03 (2019-12-04)

Tools: ESD wrist strap, ESD gloves, Phillips screwdriver, step ladder, labels, marker

Material: multi-functional sensor

A reserved multi-functional sensor has a base. You can replace the old base if it is damaged or does not

match the buckle of the reserved multi-functional sensor.

6 Parts Replacement

Table of Contents

Fusionmodule2000