Replacing A Water Sensor (Point Type) - Huawei FusionModule1000A20 Maintenance Manual

FusionModule1000A20 CT Solution
Maintenance Guide

5.3.9 Replacing a Water Sensor (Point Type)

Prerequisites
Spare water sensors of the same model are available and functional.
Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Material: spare water temperature sensor
Documents: monitoring device layout, management system initial configuration table
Skill requirement: weak-current engineer
Procedure
Step 1 Locate the water sensor to be replaced based on the alarm information on the monitoring
software terminal. Figure 5-18 shows a point-type water sensor.
Figure 5-18 Point-type water sensor
Step 2 Remove the locking bolts of the water sensor using a Phillips screwdriver, and remove the
water sensor, as shown in Figure 5-19.
Issue 01 (2019-02-25)
For the diagrams and tables, see the initial configuration parameter manual for the solution in use.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
88