Huawei FusionModule1000A40 ICT Solution Maintenance Manual page 65

FusionModule1000A40 ICT Solution
Maintenance Guide
If the condition allows, switch off the upstream circuit breaker of the PD510 electricity meter
to be replaced.
Impact on the System
Certain services of the FusionModule1000 are interrupted.
Preparations
Tools: Phillips screwdriver, protective gloves
Material: spare PD510 electricity meter
Documents: documents delivered with the PD510 electricity meter, management system
initial configuration table
Skill requirement: power distribution system engineer
Procedure
Step 1 (Optional) Remove the screws on the left of the PD510 electricity meter panel by using a
Phillips screwdriver and open the panel.
Step 2 Switch off the upstream circuit breaker of the electricity meter.
Step 3 Remove the terminal block from the PD510 electricity meter, and gently press the latch
outwards to remove the terminal block.
Step 4 Remove the faulty PD510 electricity meter, and install a new PD510 electricity meter, and
insert the latch.
Step 5 Install the removed terminal block, and ensure that the terminal block is connected properly.
Step 6 (Optional) Install the panel of the PD510 electricity meter.
Step 7 Configure the address and baud rate of the PD510 by referring to the management system
initial configuration table.
Step 8 Configure the PD510 electricity meter by following instructions in documents delivered with
the PD510 electricity meter.
Step 9 Check that the new PD510 electricity meter is working properly.
----End
Follow-up Procedure
Dispose of the removed PD510 electricity meter that is confirmed faulty.
Issue 01 (2019-03-05)
For the table, see the initial configuration parameter manual for the solution in use.
After power-on, press buttons on the PD510 panel, and check whether the LCD of the electricity meter
displays information properly.
Copyright © Huawei Technologies Co., Ltd.
4 Parts Replacement
58