Huawei FusionModule1000A40 ICT Solution Maintenance Manual page 136

FusionModule1000A40 ICT Solution
Maintenance Guide
Figure 4-69 Removing the cover
Step 3 Remove the two cables using a Phillips screwdriver.
Step 4 Remove screws from the horn strobe using a Phillips screwdriver, and remove the base.
Step 5 Reconnect cables in the same way.
Figure 4-70 Connecting cables
Step 6 Install the new horn strobe base in the same way and tighten the screws.
Step 7 Reinstall the cover in the same way and tighten the screws.
Issue 01 (2019-03-05)
While removing cables, label the cables with its corresponding terminal ports for later connection.
Connect the black wire to the leftmost binding post, and connect the red wire to the middle binding post.
Copyright © Huawei Technologies Co., Ltd.
4 Parts Replacement
129