Replacing An External Camera - Huawei FusionModule1000A40 ICT Solution Maintenance Manual

FusionModule1000A40 ICT Solution
Maintenance Guide
Step 4 Install the new camera by following instructions in documents delivered with the camera,
tighten the screws to secure the camera to the base, and reconnect the network cable in the
original way.
Step 5 Adjust the angle of the camera to cover the monitored area by following instructions in
documents delivered with the camera, and reinstall the transparent cover.
Step 6 Configure the camera by referring to the management system initial configuration table in the
initial configuration parameter manual for the solution in use.
Step 7 Check that the new camera is working properly.
----End
Follow-up Procedure
Dispose of the removed camera that is confirmed faulty.

4.3.7 Replacing an External Camera

Prerequisites
A spare external camera of the same model is available and functional.
Impact on the System
None
Preparations
Tools: Phillips screwdriver (1# and 2#)
Material: spare external camera
Documents: documents delivered with the external camera, external camera installation
position diagram, external camera wiring diagram, management system initial configuration
table
Skill requirement: extra low voltage (ELV) engineer
Procedure
Step 1 Remove the network cable connected to the external camera.
Step 2 Remove the faulty camera using a Phillips screwdriver.
Step 3 Install the new camera by following instructions in documents delivered with the external
camera.
----End
Issue 01 (2019-03-05)
The original parameter settings can be used.
For the diagrams and tables, see the quick installation guide and initial configuration parameter manual
for the solution in use.
Copyright © Huawei Technologies Co., Ltd.
4 Parts Replacement
101